Rust-Oleum Painter's Touch 2X Ultra Cover Satin Sweet Pea (model 249063) is a general-purpose aerosol for interior and exterior wood, metal, most plastic, wicker and more. Rust-Oleum rates the 2X Ultra Cover line at about twice the coverage of its other matching general-purpose sprays, with any-angle spray so you can coat hard-to-reach spots, even upside down. This is the 12 oz can in Satin Sweet Pea. Specs below are from Rust-Oleum TDS PT2X-02 (Form GDH-1269, Rev. 013019) for Painter's Touch 2X Ultra Cover Satin sprays.
Specs
| Resin |
Acrylic modified alkyd |
| Finish |
Satin Sweet Pea |
| Size |
12 oz aerosol (fill weight 12 oz) |
| Coverage |
8-12 sq ft per can at 1.0-2.0 mils DFT (assumes 15% loss) |
| Dry time (70 F, 50% RH) |
Touch 20 minutes; handle 1 hour; fully dry 24 hours |
| Recoat |
Within 1 hour or after 48 hours; clear coat in 2-3 light coats a few minutes apart |
| Spray conditions |
50-90 F, humidity below 65%, well ventilated |
| Dry heat resistance |
200 F surface temperature max |
| MIR |
Max 0.95 |
| Clean up |
Xylene or mineral spirits for wet paint |
| Not for |
Galvanized steel; objects that may exceed 200 F surface temperature |
| Manufacturer part # |
249063 (UPC 020066187200) |
How to use it
- Wash off dirt, grease, oil, salt and contaminants; rinse and let dry. Remove loose paint and rust with a wire brush or sandpaper. Scarify smooth, hard or glossy finishes by sanding.
- For bare wood or metal, Rust-Oleum recommends a Painter's Touch 2X Ultra Cover primer first, such as Painter's Touch 2X Flat Primer.
- Shake the can vigorously for one minute after the mixing ball rattles. Shake often during use. Do not strike the can if the ball fails to rattle; contact Rust-Oleum.
- Hold the can upright 10-16 in from the surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can moving. Apply 2 or more light coats a few minutes apart.
- When finished, wipe the tip before storing. If the valve clogs, twist and pull off the spray tip and rinse it in mineral spirits. Do not stick a pin into the stem.
FAQ
How much area does one can cover?
Rust-Oleum rates practical coverage at 8-12 sq ft per can at the recommended film thickness. Plan for 2 or more light coats.
When can I recoat or clear-coat?
At 70 F and 50% RH, apply a second coat or clear coat within 1 hour or after 48 hours. On plastic, Rust-Oleum says maximum adhesion and durability develop in 5-7 days.
Can I spray polyethylene plastic?
Some plastics, such as polyethylene storage containers, may not take paint well. Rust-Oleum says to test in a hidden area first.
What temperatures can I spray in?
Use outdoors or in a well-ventilated area such as an open garage when the air is 50-90 F and humidity is below 65%. Avoid very windy or dusty conditions.
Shop more Rust-Oleum, spray paint and spray paint for metal.