General Finishes High Performance Topcoat, Gloss, Pint
General Finishes High Performance Water-Based Topcoat, Gloss, Pint is a clear interior wood finish. This pint can covers about 65 to 75 sq ft per coat. Gloss is the highest of the five sheens, a bright, reflective finish.
General Finishes High Performance Water-Based Topcoat protects interior wood with a clear finish. Apply it by brush, roller or sprayer, and choose the sheen that suits your project.
Features
- Resists water and household chemicals on cabinets, furniture and trim
- Dry to the touch in 30 minutes or more; wait at least 2 hours before recoating
- Water-based, with soap-and-water cleanup
- Five sheens: Dead Flat, Flat, Satin, Semi-Gloss and Gloss
- Goes over raw wood, sealed finishes that pass an adhesion test, and oil-based finishes dried 72 hours
Best for
Interior furniture, cabinets, doors, trim and millwork, on raw wood or over a finish that passes an adhesion test. It is an interior product; for outdoor wood, use an exterior finish.
Specs
| Base | Water-based polyurethane |
|---|---|
| Use | Interior |
| Sheens | Dead Flat, Flat, Satin, Semi-Gloss, Gloss |
| Coverage | Pint 65 to 75 sq ft; quart 125 to 150 sq ft; gallon 500 to 600 sq ft |
| Dry to touch | 30 minutes or more |
| Recoat | 2 hours or more |
| Full cure | 21 days |
| Coats | 2 to 3 |
| Apply with | Brush, roller or sprayer |
| Thinning | Distilled water, 5% to 10% if needed |
| Cleanup | Soap and water |
| Manufacturer part # | PTHG |
| VOC | Under 175 g/L |
How to apply
- Sand raw wood smooth. On a finished piece, clean, scuff sand and test adhesion in a hidden spot.
- Stir well.
- For hand application, lay on a liberal wet coat along the grain. Use smooth strokes without pressure or repeated back-brushing.
- Allow at least 2 hours at 70 °F and 50% humidity. Cool or humid conditions, thick coats and sealed surfaces need longer. Sand lightly only when the finish powders, then recoat. Apply 2 to 3 coats.
- For spraying, strain first and apply a 3 to 5 mil wet film. Check the tip with your equipment supplier; use the recommended NIOSH/MSHA-approved respirator and ventilation.
- Treat it gently during the 21-day cure under ideal conditions.
Good to know
- Do not apply over white or light paint: General Finishes warns of yellowing.
- Do not use over linseed oil or Danish oil.
- Over oil-based stain or finish, let it dry at least 72 hours first.
- Do not mix Dead Flat with the other sheens.
- Warning: may cause an allergic skin reaction. Wear gloves and read the safety data sheet.
Questions
What is the difference between dry time and cure time? Touch-dry and recoat are separate stages. The listed times assume 70 °F and 50% humidity; full cure takes about 21 days. Wait longer when drying conditions differ.
How much do I need? Multiply the area by the number of coats, then divide by the coverage for your can size. Allow for waste and absorbent wood.
Can I use it outdoors? No. It is made for interior surfaces.
Which sheen should I pick? Dead Flat and Flat have the least shine. Satin is in the middle; Semi-Gloss and Gloss are progressively shinier. Do not mix Dead Flat with another sheen.