Zinsser B-I-N Advanced is a synthetic shellac-based primer sealer for whole-surface interior priming and exterior spot priming. It blocks tough stains and odors, dries fast with low odor, and cleans up with soap and water. Use it under and over any latex or oil-based paint, on bare or painted wood, drywall, cured plaster, masonry, galvanized metal and PVC.
Highlights
- Blocks stains from water, nicotine, grease, oil, soot, rust, mildew, tannin, crayon and lipstick
- Seals odors from fire damage, smoke, cigarettes, pet urine and fireplaces
- Seals knots and sap streaks
- Sticks to glossy enamel, varnish, paneling, laminate, glass and ceramic tile without sanding or de-glossing
- One coat primes most surfaces
Specifications
| Size / color |
1 quart / white (tint to off-white or pastels with up to 2 oz universal colorant per gallon) |
| Coverage |
75-100 sq ft per quart (300-400 sq ft per gallon), depending on method and porosity |
| Dry times |
Touch 25 minutes, recoat 45 minutes, stain sealing 2 hours, full hardness 7 days (70 F, 50% RH) |
| Apply at |
50-90 F, humidity below 85% |
| Apply with |
Quality brush, 3/8 in. nap roller or airless sprayer (0.015-0.017 in. tip, 1700-2200 psi) |
| Thinning |
Up to 10 oz of water per gallon, if needed |
| VOC |
Under 100 g/L |
| Clean up |
Warm soap and water |
| Manufacturer part # |
271009 |
How much do I need?
One quart primes about 75-100 sq ft in one coat, which is usually all you need. Very porous surfaces may need a second coat, which halves that area to about 37-50 sq ft. For spot priming stains and knots, a quart goes a long way.
How to apply
- Clean the surface of dust, grime, grease, wax and mildew. Remove peeling paint and sand the edges smooth. Remove as much of any stain as you can, then let the surface dry.
- Mix or shake well. Apply one coat with a brush, roller or airless sprayer; for best results, prime the entire surface.
- Topcoat after 45 minutes. Over knots and stains, allow 2 hours. A water stain may show in the primer as it dries; Zinsser notes it is locked in and will not bleed into the topcoat.
Good to know
Not for full exterior priming, very humid rooms, or surfaces under water or in prolonged contact with it. Outdoors, spot prime only under high-hiding paint, or prime the whole surface with Bulls-Eye 1-2-3 after spot priming. Do not mix with other products. Read the B-I-N Advanced technical data sheet.
Shop related
See more Zinsser primers and the Zinsser primer guide, shop prep and patch supplies, or plan the job with the cabinet project cart or the paint-a-room project cart.