Modern Masters Metallic Paint, Ground Coffee, Satin, Quart
Modern Masters Metallic Paint, Ground Coffee, Satin, Quart is intended for interior; exterior use requires MasterClear UV Protective Clear Topcoat per TDS use.
Features
- Water-based acrylic metallic paint
- Mica and traditional pigments
- Intermixable colors
- Satin metallic finish
Best for
Properly primed interior walls; Ceilings; Columns; Trim; Doors; Furniture; Paintable wallcoverings
Specs
| Color or finish | Ground Coffee |
|---|---|
| Selected size | Quart |
| Base | water |
| Use | interior; exterior use requires MasterClear UV Protective Clear Topcoat per TDS |
| Coverage | 208-320 sq ft/gallon |
| Touch dry | 30 minutes in TDS physical properties; application text says approximately 1 hour |
| Recoat | Approximately 30 minutes |
| Full cure | 24 hours |
| Application conditions | Do not apply below 58°F or above 85°F |
| Coats | Opaque colors: 2; semi-opaque: 3; sheer colors: translucent overcoat |
| Apply with | Brush; Roll; Spray with HVLP or conventional cup gun |
| Thinning | For spraying, up to 16 fl oz water per gallon; for rolling, up to 16 fl oz Metallic Paint Collection Extender per gallon |
| Cleanup | Soap and warm water immediately after use |
| VOC | <350 g/L across the line per TDS; color-specific SDS may vary |
| Topcoat compatibility | MasterClear UV Protective Clear Topcoat required for exterior use and optional for interior scuff and abrasion resistance |
| Manufacturer part # | ME52532 |
How to apply
Start with the manufacturer's preparation steps: Remove dust, dirt, oil, grease and loose paint; Prime clean dry surface with recommended compatible primer and let dry, preferably overnight; Test color and technique on small area.
- Clean, repair and prime surface
- Mix paint and test a sample board
- Brush, roll or spray while maintaining a wet edge
- Apply recommended coats by opacity
- Use MasterClear UV topcoat for exterior exposure
Good to know
Use limits: Unprimed surfaces; Airless sprayer; Application outside 58-85°F.
Keep the recoat time and full cure time separate when planning the project. The recoat figure tells you when another coat can be applied; it does not replace the full cure guidance.
Questions
How much will I need?
Use these manufacturer coverage figures: 208-320 sq ft/gallon. Match the figure to the container size, and account for the stated number of coats.
When can I apply another coat?
The listed manufacturer recoat guidance is Approximately 30 minutes. Follow the application conditions and instructions for this product.