Minwax Design Series Wood Effects, Charred Wood, Quart
Minwax Design Series Wood Effects, Charred Wood, Quart is intended for interior use.
Features
- Reacts with wood tannins
- Weathered Gray and Charred Wood variants
- Oak preferred for effect
Best for
Unfinished wood furniture; Cabinets; Doors; Trim; Molding
Specs
| Color or finish | Charred Wood |
|---|---|
| Selected size | Quart |
| Base | water |
| Use | interior |
| Coverage | 275 sq ft/quart |
| Touch dry | 30 minutes at 77°F and 50% relative humidity |
| Recoat | 1 hour |
| Application conditions | Above 50°F and below 85% relative humidity |
| Apply with | Synthetic brush; Foam brush |
| Thinning | Do not thin |
| Cleanup | Soap and warm water |
| VOC | 0 in TDS for both variants |
| Topcoat compatibility | Minwax Polycrylic Ultra Flat optional for added durability; darkens appearance |
| Manufacturer part # | 40414 |
How to apply
Start with the manufacturer's preparation steps: Start with clean, dry bare or stripped wood; Sand medium to fine, finishing with 220 grit; Remove dust; Test on hidden spot because wood tannins cause different effects.
- Prepare bare clean dry wood
- Stir; do not shake
- Brush evenly with grain without wiping
- Let dry 30-60 minutes
- Optionally protect with Polycrylic Ultra Flat
Good to know
Use limits: Floors; Continuously wet or submerged surfaces.
Warning: Charred variant: suspected of causing cancer; California cancer and reproductive harm warning.
None: Weathered Gray SDS not classified as hazardous; California reproductive harm warning.
Questions
How much will I need?
Use these manufacturer coverage figures: 275 sq ft/quart. Match the figure to the container size, and account for the stated number of coats.
When can I apply another coat?
The listed manufacturer recoat guidance is 1 hour. Follow the application conditions and instructions for this product.