General Finishes Enduro Water-Based White Poly, Satin, Gallon
General Finishes Enduro Water-Based White Poly, Satin, Gallon is intended for Interior only use.
Features
- High-solids pigmented white finish
- Tintable; 5% short-filled
- Spray application
- Self-sealing
- PFAS-free
Best for
Interior cabinets; Millwork; Raw or stained wood; Properly prepared existing finishes
Specs
| Color or finish | White, Satin |
|---|---|
| Sheen | Satin |
| Selected size | Gallon |
| Base | Water-based urethane/acrylic blend |
| Use | Interior only |
| Coverage | 450 sq ft/gallon |
| Touch dry | 30+ minutes |
| Recoat | 1+ hour |
| Full cure | 21 days |
| Application conditions | Dry times based on 70°F and 50% humidity |
| Coats | 3 |
| Apply with | Spray; HVLP 1.3-1.5 mm |
| Thinning | Distilled water, start at 5%, up to 10% by volume |
| Cleanup | Soap and water or GF Brush & Gun Cleaner immediately |
| VOC | Satin <250 g/L |
| Topcoat compatibility | Self-sealing; GF White Undercoat or Stain Blocker recommended beneath; clear topcoat not recommended due yellowing |
| Manufacturer part # | GWS |
How to apply
Start with the manufacturer's preparation steps: Raw wood: sand 120 then 150 or 220 grit and remove dust; Sealed surface: clean with 50:50 denatured alcohol/water, dry 1-2 hours, sand 220-320 grit; Over existing finish: 2 coats GF Stain Blocker before White Poly.
- Prepare and prime substrate
- Stir thoroughly
- Thin if needed and spray 3 coats
- Sand between coats
- Allow 21 days to cure
Good to know
Use limits: Exterior use; Brush application; Clear topcoat over White Poly due yellowing; Linseed or Danish oil finishes.
Warning: 2023 Satin SDS: may cause an allergic skin reaction.
Keep the recoat time and full cure time separate when planning the project. The recoat figure tells you when another coat can be applied; it does not replace the full cure guidance.
Questions
How much will I need?
Use these manufacturer coverage figures: 450 sq ft/gallon. Match the figure to the container size, and account for the stated number of coats.
When can I apply another coat?
The listed manufacturer recoat guidance is 1+ hour. Follow the application conditions and instructions for this product.