General Finishes Enduro-Var II Topcoat, Amber, Flat, Gallon
General Finishes Enduro-Var II Topcoat, Amber, Flat, Gallon is intended for Interior only use.
Features
- More than 70% renewable resources
- Lighter amber than original formula
- Oil-modified water-based urethane
- Water resistance
- Brushable and sprayable
Best for
Interior raw wood; Stained wood; Non-white painted wood; Cabinets; Trim; Doors; Furniture
Specs
| Color or finish | Amber, Flat |
|---|---|
| Sheen | Flat |
| Selected size | Gallon |
| Base | Water-based oil-modified polyurethane |
| Use | Interior only |
| Coverage | 125-150 sq ft/quart; 500-600 sq ft/gallon |
| Touch dry | 30+ minutes |
| Recoat | 2+ hours |
| Full cure | 21 days at 70°F and 50% humidity |
| Application conditions | Recommended 70°F and 50% humidity, out of direct sunlight |
| Coats | 3; TDS says 3-4 total coats with sealer |
| Apply with | Brush; Roll; Spray |
| Thinning | Distilled water, start at 5%, up to 10% by volume; TDS also permits GF Extender/Accelerator |
| Cleanup | Soap and water for hands; GF Brush & Gun Cleaner for equipment |
| VOC | Flat <250 g/L |
| Topcoat compatibility | Self-sealing; Enduro-Var II compatible with all GF products, unlike original Enduro-Var |
| Manufacturer part # | B087-GA |
How to apply
Start with the manufacturer's preparation steps: Raw wood: sand 120 then 150 or 220 grit; remove dust; Existing finish: current page says remove completely and test schedule over raw wood.
- Sand raw wood and remove dust; remove existing sealed finish
- Stir and test adhesion
- Brush, roll or spray three coats
- Sand lightly between coats and remove dust
- Allow 21 days for full cure
Good to know
Use limits: Bright white finishes, due to ambering; Exterior use; Other substrates per TDS.
Warning: Flat SDS: causes skin and serious eye irritation; may cause respiratory irritation; harmful to aquatic life.
: Current manufacturer page carries California warning for N-methyl-2-pyrrolidone and reproductive harm.
Keep the recoat time and full cure time separate when planning the project. The recoat figure tells you when another coat can be applied; it does not replace the full cure guidance.
Questions
How much will I need?
Use these manufacturer coverage figures: 125-150 sq ft/quart; 500-600 sq ft/gallon. Match the figure to the container size, and account for the stated number of coats.
When can I apply another coat?
The listed manufacturer recoat guidance is 2+ hours. Follow the application conditions and instructions for this product.