Old Masters Water-Based Wood Stain, 777 Dark Mahogany, Half Pint
Old Masters Water-Based Wood Stain, 777 Dark Mahogany, Half Pint is intended for interior use.
Features
- Semi-transparent
- Two currently listed ready-mixed colors
- Natural Tint Base can be tinted with universal colorants
Best for
Bare interior wood; Cabinets; Furniture; Doors; Trim; Crafts; Floors
Specs
| Color or finish | 777 Dark Mahogany |
|---|---|
| Sheen | Clear |
| Selected size | Half Pint |
| Base | water |
| Use | interior |
| Coverage | Approximately 400 sq ft/gal |
| Touch dry | Approximately 2 to 3 hours at 70°F and 50% RH |
| Recoat | Additional stain coats after first coat is thoroughly dry |
| Application conditions | Air and surface 60°F to 90°F; humidity 30% to 70%; do not apply below 55°F |
| Apply with | Nylon/polyester brush; Foam brush; Staining pad; Cloth; Sprayer |
| Thinning | Not recommended; if stain dries too fast, 5% to 10% water may be added |
| Cleanup | Soap and water |
| VOC | 250 |
| Topcoat compatibility | Masters Armor or other Old Masters clear finish; most lacquers, varnishes and polyurethanes after compatibility test; wait 2 to 3 hours |
| Manufacturer part # | 77716 |
How to apply
Start with the manufacturer's preparation steps: Clean and dry; remove dirt, wax, grease, and glue; Wet bare wood to raise grain, let dry, sand smooth with grain, and remove dust; Completely remove prior finish before staining previously finished surfaces.
- Clean, grain-raise, dry, sand, and dust wood
- Stir stain before and during use
- Apply liberal even coat, maintaining wet edge
- Wipe off excess while wet in grain direction
- Allow to dry before protective finish
Good to know
Use limits: Previously finished surfaces until old finish is completely removed.
: Natural Tint Base 76101 SDS says not hazardous under OSHA 2012 Hazard Communication Standard.
Questions
How much will I need?
Use these manufacturer coverage figures: Approximately 400 sq ft/gal. Match the figure to the container size, and account for the stated number of coats.
When can I apply another coat?
The listed manufacturer recoat guidance is Additional stain coats after first coat is thoroughly dry. Follow the application conditions and instructions for this product.