Old Masters Armor Interior Water-Based Finish, Gloss, Quart
Old Masters Armor Interior Water-Based Finish, Gloss, Quart is intended for interior use.
Features
- Clear finish
- Self-sealing
- Part B hardener option for floors
- Dries clear with slight wood amber effect over white or pastel coatings
Best for
Wood floors; Cabinets; Furniture; Woodwork; Previously finished surfaces after sanding; Fully dry stained surfaces
Specs
| Color or finish | Clear |
|---|---|
| Sheen | Gloss |
| Selected size | Quart |
| Base | water |
| Use | interior |
| Coverage | Approximately 300 to 400 sq ft/gal at 3 to 5 wet mils |
| Touch dry | Within 30 minutes at 70°F and 50% RH |
| Recoat | 1 to 2 hours; dry-time paragraph says ready after 1 hour at 70°F and 50% RH |
| Full cure | Curing to ultimate hardness during first week; light use after 24 hours |
| Application conditions | Air and surface 60°F to 90°F; humidity 30% to 70% |
| Coats | Three |
| Apply with | Synthetic fiber brush; Foam brush; Flat pad; Sprayer; Lambswool applicator for large flat areas |
| Thinning | Not recommended; if needed add small amount of water, up to 8 oz for spray application |
| Cleanup | Warm soapy water; rinse clean |
| VOC | TDS: less than 275 g/L; see notes for variant SDS value |
| Topcoat compatibility | Self-sealing; test over paints and stains; Masters Armor Part B Hardener may be added for floors, one 4 oz container per gallon |
| Manufacturer part # | 72304 |
How to apply
Start with the manufacturer's preparation steps: Clean and dry; remove dirt, wax, grease, glue and other contaminants; Sand new wood from medium to fine grit with grain; remove dust; Sand previously finished surfaces with 220 grit to remove gloss and imperfections; Allow oil-based stain at least 48 hours drying before topcoating; Do not use steel wool or tack rag.
- Prepare surface and remove sanding dust
- Stir thoroughly; do not shake; test adhesion
- Apply full even coats with grain at 3 to 5 wet mils
- Wait 1 to 2 hours; lightly sand with 220 grit and remove dust
- Reapply for three coats total
Good to know
Use limits: Over shellac, lacquer, or fillers, stains, or sealers containing stearates; Over sanding sealer on floors.
: Not considered hazardous under OSHA Hazard Communication Standard 2024
Keep the recoat time and full cure time separate when planning the project. The recoat figure tells you when another coat can be applied; it does not replace the full cure guidance.
Questions
How much will I need?
Use these manufacturer coverage figures: Approximately 300 to 400 sq ft/gal at 3 to 5 wet mils. Match the figure to the container size, and account for the stated number of coats.
When can I apply another coat?
The listed manufacturer recoat guidance is 1 to 2 hours; dry-time paragraph says ready after 1 hour at 70°F and 50% RH. Follow the application conditions and instructions for this product.